Cu 相变与气体扩散电极脉冲 CO2 还原中选择性恢复的关系
Relating Cu Phase Transitions to Selectivity Recovery During Pulsed CO2 Reduction on Gas Diffusion Electrodes
一项发表于 ACS Catalysis 的研究把不同电位脉冲的电位-pH 轨迹映射到 CO2 饱和 KCl 与 KHCO3 电解液的 Cu 相图上,分析脉冲中热力学可及的 Cu 相。
- 背景
- 脉冲电化学 CO2 还原被视为缓解 Cu 催化剂失活、维持 C2+ 选择性的可行手段,但氧化脉冲期间 Cu 的氧化态与催化剂附近局部电解液 pH 难以解析,多孔气体扩散电极内部尤其如此,机制认识因此受限。
- 做法
- 研究考察不同电位脉冲曲线对 CO 与 C2+ 选择性恢复的影响,将脉冲的电位-pH 轨迹映射到 CO2 饱和的 KCl 与 KHCO3 电解液的计算电位-pH Cu 相图上,以判断脉冲期间热力学可达的 Cu 相。
- 结论
- 局部碱性 pH 下的突变脉冲同时恢复 C2+ 与 CO;局部 pH 与体相平衡的准绝热脉冲则只恢复 CO、与 C2+ 无关。在酸性 KCl 中准绝热脉冲下无 Cu 氧化物热力学可达,C2+ 恢复被归因于 Cu 的溶解与再沉积,说明脉冲期间即使暂时生成 Cu 氧化物也并非 C–C 耦合所必需;KHCO3 中 Cu 氧化物在脉冲期间仍热力学可达。恢复 CO 选择性的氧化电荷随此前还原时间缩放,推测对应表面毒化物种的移除。
- 意义
- 结果提示可依据电解液、电位与 pH 分辨的 Cu 相图来设计脉冲方案,作者提出该框架可推广到其他催化剂与电解液。上述机制解释中,氧化电荷与表面毒化物移除的联系仍属推测。
原文摘要
出版方登记 · CrossrefPulsed electrochemical CO2 reduction on Cu catalysts represents a promising strategy to mitigate catalyst degradation and sustain high selectivity toward multicarbon (C2+) products. However, developing a detailed mechanistic understanding of the oxidative pulses remains challenging due to the inability to resolve the Cu oxidation state and the local electrolyte pH in the vicinity of the catalyst, especially inside a porous gas diffusion electrode. In this study, we investigate the impact of different potential pulse profiles on the recovery of CO and C2+ product selectivity, the latter representing C–C coupling. The potential-pH trajectories of the pulses are mapped onto calculated potential-pH Cu phase diagrams for CO2-saturated aqueous KCl and KHCO3 electrolytes to identify the thermodynamically accessible Cu phases during pulses. We show that abrupt pulses at a local alkaline pH lead to simultaneous C2+ and CO recovery. In contrast, quasi-adiabatic pulses, where the local pH remains equilibrated with the bulk pH, recover CO selectivity independently of C2+ products. Furthermore, in acidic KCl electrolytes, where no Cu oxide is thermodynamically accessible during a quasi-adiabatic pulse, the recovery of C2+ is attributed to Cu dissolution and redeposition. Importantly, this finding demonstrates that the formation of a Cu oxide phase, even temporarily during the pulse, is not required for C–C coupling. In contrast, in KHCO3 electrolyte, the formation of a Cu oxide phase remains thermodynamically accessible during pulses. Moreover, we show that the oxidative charge of the pulse recovering CO selectivity scales with prior reduction time, hypothesized to be a removal of surface poisoning species. Our findings enable rational design of pulse protocols based on electrolyte-, potential-, and pH-resolved Cu phase diagrams and provide a framework that can be extended to other catalysts and electrolytes.
页面未能读取全文,以上为出版方登记的摘要;方法与图表见原文
本页是 AI 精读,不转载论文原文;完整论文(含方法、图表与参考文献)见原文
来源:ACS Catalysis · doi.org