跳到正文
Advanced Energy Materials· Wang·· 9 天前AI 评分50

钙钛矿-硅叠层太阳能电池填充因子损失机制的表征

Characterizing Fill Factor Limitations in Perovskite‐Silicon Tandem Solar Cells

AI 导读

研究通过电致发光表征与解析模型识别钙钛矿-硅叠层太阳能电池填充因子损失的来源,发现除串联电阻损失外,光 shunt(photoshunt)是额外损失机制:光照下并联 shunt 电阻表观降低,源于电荷提取与吸收层及界面复合之间的竞争。

AI 深度导读基于原文整理的分节解读
背景
单片钙钛矿-硅叠层太阳能电池的光电转换效率已接近35%,但距离其热力学极限仍有明显差距,其中填充因子(FF)损失是主要原因。此前对FF损失来源的识别缺乏系统方法,电致发光表征虽能给出扣除串联电阻损失后的潜在FF,却无法完整解释实测FF的限制。
做法
工作提出一套识别FF损失机制的方法。电致发光表征用于给出无串联电阻损失时的潜在FF,并显示这仍不足以解释观测到的FF限制。作者引入光 shunt(photoshunt)作为额外损失机制:在钙钛矿太阳能电池中,并联 shunt 电阻在光照下会表观降低。通过解析模型,作者将 photoshunt 归因于电荷提取(受传输层性质与电场支配)与吸收层及界面复合之间的竞争。随后用等效电路模型量化其对子电池和叠层FF的影响,并考虑硅子电池的双二极管特性对叠层FF损失的贡献。测量在光谱独立的LED光照下对叠层器件进行。
结论
解析模型显示 photoshunt 源于电荷提取与复合的竞争,等效电路模型可量化其对子电池和叠层FF的影响;硅子电池的双二极管特性同样会影响叠层FF损失。在光谱独立LED光照下对叠层器件的测量表明,photoshunt 损失可被底部电池受限条件掩盖,这解释了为何略偏底部电池受限的叠层设计更受偏好。
意义
该结果把叠层FF损失拆解为串联电阻之外的光 shunt 与硅子电池双二极管特性等来源,并说明底部电池受限条件会隐藏 photoshunt 损失。对叠层电池设计而言,这意味着略偏底部电池受限的设计倾向有可解释的测量学成因;改善电荷传输、降低复合以减少 photoshunt,有望使器件在更接近电流匹配的条件下工作,同时减小FF与效率损失。
局限
摘要指出电致发光表征无法完整解释观测到的FF限制,说明单一表征手段存在盲区;photoshunt 损失在底部电池受限条件下可被隐藏,意味着常规测量条件可能低估该损失。
下一步
作者提出通过改善电荷传输和降低复合来减少 photoshunt,从而使器件在更接近电流匹配的状态下运行,并尽量减少FF和效率损失。

原文摘要

出版方登记 · Crossref

Monolithic perovskite‐silicon tandem solar cells have achieved power conversion efficiencies approaching 35%. However, a significant gap remains to their thermodynamic limit, primarily due to fill factor ( FF ) losses. This work presents a methodology to identify the underlying mechanisms of the losses. Electroluminescence characterization reveals the potential FF without series resistance losses but cannot fully explain the observed FF limitations. An additional loss mechanism is the photoshunt, a phenomenon which the parallel shunt resistance apparently reduces under illumination in perovskite solar cells. Using an analytical model, we show that the photoshunt originates from competition between charge extraction, governed by transport‐layer properties and electric field, and recombination in the absorber and at interfaces. An equivalent circuit model quantifies its impact on subcell and tandem FF . Additionally, the two‐diode property of the Si subcell can also influence the tandem FF losses. Measurements on tandem devices under spectrally independent LED illumination show that photoshunt losses can be hidden under bottom‐cell‐limited conditions, explaining the preference for slightly bottom‐cell‐limited tandem designs. Reducing the photoshunt through improved charge transport and reduced recombination could enable operation closer to current matching while minimizing FF and efficiency losses.

页面未能读取全文,以上为出版方登记的摘要;方法与图表见原文

本页是 AI 精读,不转载论文原文;完整论文(含方法、图表与参考文献)见原文

来源:Advanced Energy Materials · doi.org